kaslrfinder – Kernel Address Space Layout Randomization (KASLR) Recovery Software
KASLRfinder is a small utility that can be used to find where in memory the Windows 10 kernel and its drivers are loaded – despite the addresses being randomized by Kernel Address Space Layout Randomization (KASLR).
The utility can be run as a normal program and requires no administrative privileges.
It works by timing the execution times of failed instructions inside Transactional Synchronization Extensions (TSX) block. TSX was first introduced in Haswell based CPUs; but got disabled due to problems. The TSX instructions are available on all Skylake CPUs. .
- Skylake based CPU or newer (some Haswells may work too)
- Windows 10 64-bit
- KASLRfinder is far from stable. It won’t crash; but some times it will fail to find the memory addresses.
- KASLRfinder has only been tested on Windows 10 1607 / Skylake CPU.
- KASLRfinder haven’t been tested on systems with Virtualization Based Security (VBS) or Hyper-V.
- Feedback is appreciated; but I do not plan to officially support this utility.
KASLRfinder is able to:
- Locate the kernel address within an error margin of 1MB.
- Locate a driver or module address exactly – using a signature based search.
- Generate new signatures based on user supplied memory addresses.
Search for the kernel base address within an error margin of 1MB:
Search for the exact base address of the driver tcpip.sys (1607/November patches):
kaslrfinder.exe -sig 01809a0155800100
Generate a signature for the driver loaded at: 0xFFFFF80878880000 with size: 0x0005D000:
kaslrfinder.exe -sigbase 0xFFFFF80878880000 -size 0x0005D000
Find out what’s wrong with the signature for a driver if it’s not detected and the address is already known:
kaslrfinder.exe -sig 01809a015580010 -sigbase 0xFFFFF80878880000 -size 0x0005D000
Displayed the measured default time threshold (-v = verbose) and measure the timing for address 0xFFFFF80000000000 (-gettime)
kaslrfinder.exe -v -gettime 0xFFFFF80000000000
Set a custom measurement threshold. This value should be inside the range between executable and non-executable memory.
kaslrfinder.exe -threshold 0x90
The best way to find the addresses required to generate the signatures is by using pcileech. Just insert the pcileech kernel module into the target computer. Then use the wx64_driverinfo module.
If a signature is created and it won’t work later on it may be because of changes in the signature itself, or errors in detecting it. If there are errors in detecting it try to run kaslrfinder specifying both the signature and the known based address and size to get the potential hint about whats wrong. Most times its recommended shortening the signature as much as possible to improve accuracy. If the signature is shortened enough false positives may occur though. If shortened it must be shortened in 2-byte (4-hex chars) decrements.
tcpip.sys – Windows 10 1607 – November 2016 – 10.0.14393.351:
msrpc.sys – Windows 10 1607 – November 2016 – 10.0.14393.0:
acpi.sys – Windows 10 1607 – November 2016 – 10.0.14393.0:
http.sys – Windows 10 1607 – November 2016 – 10.0.14393.351: